Solar Panel Mount Brackets, 46 inch Adjustable Solar Panel Mount with Foldable Tilt Legs, Suitable for 2-4pcs 180 200 300 400 500 Watt for Roof, RV, Boat (117cm Upgraded and Reinforced 46inch 2 Sets)

Good sturdy solar panel supports, can be used on a wall, or ground.

Easy to put together, easily adjustable. I bought this so I could charge my camping battery with a 515w solar panel. Initially I had the panel leaning against the wall but found this product to make the solar panels have a little more permanent location. With the stand I can I easily move the panel. Though you will need to be careful that you don't drag the panel as it will cause the legs on the stand to buckle as they are only screwed into the panel and do not come with any reinforcement. It came with the screws I needed to mount the panel to the frame, along with some other metal screws. I believe my panel pushes the limit of the size of panel this mount can hold. Overall I'm very pleased with the product.

Been in use for six months and withstood strong winds on many occasions.

Appear to be good quality (not installed yet), but mounting holes we're not long enough for my solar panels (about 5- 6 cm too short). The distance was stated so not a fault of the product. Resolved by purchasing extra angle to be bolted on.

Nice kit to get your panels at the right angle .. even on heavier 450w panels that i have . Easy to assemble . I suppose one criticism is the instructions bit lacking, however not much to them to get it wrong.

I wanted this set to mount my large panels to the side of my house, out of the way and facing South. I wanted this set as I liked the fact you can tilt the panel with it as it's very adjustable. It's made of good quality metal and I've no doubt this will be strong enough to secure my panels for years to come.

It looks great for the money, but as someone else commented on their review, parts missing, in my case a single M8 stainless washer. Seems no way to contact seller other than a full return rather than just sending out a missing M8 washer. Need to see if I can find one or consider a full return.

Speedy delivery, item arrived in good condition. Simple assembly after reading instructions, quality looking items once assembled, unable to test as hold up on solar panel delivery. Will follow up review once panels arrive and are fitted to the supports.

Un peu fragile pour un panneau de 500w mais finalement ça va ouf

Very good quality aluminum racking for solar panels for an affordable price. I used Sikaflex 522 to glue them down to avoid making holes in the roof, which seems to have worked very well. They aren't going anywhere. :) I used a bolt with nylon washers and nylon lock nut on one end (hinge) and at the other end pins (when stowed) and added nutserts to the supports to easily tilt them to the desired angle by just threading in thumbscrews through the preexisting holes, which works great. My solar panels are 100mm wide, so I did cut the rails down to approximately that length, which was easily done with a miter saw.

Excellent product, high quality materials, easy to assemble.

Do not be fooled by the image, it is not made in the USA. Everything on the packaging says ‘made in china’. In general, it’s easy to put together and works as a cheap simple stand. It would benefit from a cross bar on the two pieces that sit parallel to each other on the ground as they try to stretch apart at any slight movement. Not super sturdy, but also won’t blow over. Also, the hardware was all included but one type of screw differed than the one shown in the instructions sheet. I would buy again and modify it myself for personal need.

The braces should be strudier. Make of thicker metal would be good. :(